This is where you select, design or edit the main map used by this procedure as explained in the Map Assignment menu.
Select No Map if your procedure body does not have a main map (you might need this for a procedure that selects a print device but does not have any output itself).
This option controls the way in which the main map is displayed on the screen. Select the required option from the Form Output Method menu.
These field is only available if you select Beside another or Over another as the output method.
Enter the number of the form to be printed over or beside. The form must already have been output using the Delay output option (See Below).Enable this option to start a new page when this procedure is completed. The page is started after the procedure body finishes but before any subsidiary procedures are executed.
Normally forms are output as soon as a procedure body completes. However, if you want to print over or beside a form, or continue to print in it in a later procedure, enable this option to delay output.